MakerBot Replicator 2x Guía para resolver problemas descargar pdf (Pagina 25)

3D Printer Guide Makerbot Replicator 2X

24 | P a g e

Troubleshooting

MakerWare

MODEL NOT AT THE SCALE WHEN OPENING FILE IN MAKERWARE

Check to ensure your 3D model was defined in mm

OCCASIONALLY WHEN OPENING MAKERWARE, A Background Service Unavailable or

No Connection to Background Service notification pops up.

in MakerWare, go to the “Services Menu” and select “Restart Background Service”.

FOR OTHER ISSUES GO TO:

http://www.makerbot.com/support/makerware/troubleshooting/

MakerBot Troubleshooting

OBJECTS DO NOT STICK TO THE BUILD PLATE:

1) Clean the build plate (wipe off with a towel) and check the film on the build plate for

bubbles, if there are bubbles, try moving the model in MakerWare to a different

location or change the film on the build plate

2) Increase build plate temperature by increments of five degrees in the printing

properties of MakerWare.

3) Try adding a raft to your model in MakerWare print properties.

4) Level the build plate (see below).

1 2 ... 20 21 22 23 24 25 26 27 28 29 30

Sin comentarios

MakerBot Replicator 2x Guía para resolver problemas Pagina 25