MakerBot Replicator 2 Manual de usuario descargar pdf (Pagina 13)

UNPACKING YOUR MAKERBOT REPLICATOR 2 CONTINUED

3a. Remove the two remaining protective

foam pieces from the bottom of the

Replicator 2’s box.

3b. Li out the accessory box. This box

contains the remaining items from the

“What’s in the Box” section.

NOTE: Your MakerBot Replicator 2 should now be

fully unpacked. We recommend that you keep the

box and foam inserts in case you need to transport

your MakerBot Replicator 2 in the future.

2a. Open the plastic covering and ﬁrmly grasp

the frame of the MakerBot Replicator 2 from

the outside. Li it out of the box and place it

on a stable surface.

NOTE: The black cable is not a handle. Do not pull

or twist the black cable at any time.

Removing the Accessory Box 1

Removing the MakerBot Replicator 2 from the Box

B SETTING UP YOUR MAKERBOT REPLICATOR 2 DESKTOP 3D PRINTER

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 59 60

Sin comentarios

MakerBot Replicator 2 Manual de usuario Pagina 13