MakerBot Replicator 2 Manual de usuario descargar pdf (Pagina 17)

10a. Locate the power supply and cable.

Attach the cable to the power supply.

10b. Ensure that the power switch on

the MakerBot Replicator 2 is set to the

OFF position.

10c. Insert the power supply connector

into the power input on the back of the

Replicator 2. Ensure that the ﬂat side of

the connector faces down.

Attaching the Power Supply

ATTACHING POWER SUPPLY AND POWERING ONMOUNTING FILAMENT SPOOL AND ATTACHING USB CABLE

11a. Plug the AC power cord into an

electrical outlet.

11b. Set the power switch to the ON position.

11c. The MakerBot Replicator 2 will display

welcome text on the LCD panel. This is the

beginning of the startup script that will

guide you through initial calibration and

your ﬁrst build.

NOTE: The socket-outlet shall be installed near

the equipment and shall be easily accessible.

Powering On the MakerBot Replicator 2

B SETTING UP YOUR MAKERBOT REPLICATOR 2 DESKTOP 3D PRINTER

Power Supply

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 59 60

Sin comentarios

MakerBot Replicator 2 Manual de usuario Pagina 17