MakerBot Replicator 2x Manual de usuario descargar pdf (Pagina 10)

Page 9

Rev.2

D. Level the build plate

To level the build plate, select Utilities > Level Build Plate on the MakerBot

control panel.

To properly level the build plate, turn each screw under the build plate 3

twists to the right (as in clockwise – use your right hand), you don’t need to

turn the screws 3 full turns, just tighten them down 3 times.

Press the MakerBot “M” button until the extruders slide over to the rear of the

print surface. Grab a piece of paper and slide it under the nozzles. Turn the

screw on the bottom of the build plate that is directly under the nozzle (the

rear screw) and slide the paper back and forth. Adjust the screw so that the

paper slides under the nozzles, but feels just a bit of friction.

Press “M” to move the nozzle to the next position, repeat the previous

operation of adjusting the screw under the nozzles until the paper slides with

a bit of friction, press “M” again and repeat.

Press “M” after the 3

adjustment and the MakerBot will send the extruders to

extreme locations, continue the process of adjusting the screws under the

nozzles and pressing “M” until it moves to the center of the build platform.

DO NOT ADJUST ANY SCREWS WHEN IT IS IN THIS LAST POSITION!

If the paper can move under the nozzle at the center location with a bit of

friction, then it is ready for the next step

Protip: For higher precision, feeler gauges can be used instead of paper. The

suggested height is 0.09mm for excellent adhesion.

Figure 5 - Leveling the Build Plate

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Sin comentarios

MakerBot Replicator 2x Manual de usuario Pagina 10