MakerBot Replicator 2x Manual de usuario descargar pdf (Pagina 15)

Page 14

Rev.2

K. Unload Filament

After you have finished printing, the filament needs to be unloaded. This can

be done by selecting: Utilities > Change Filament > Unload right.

After the nozzle has headed up, you will be prompted to remove the feed tube

and pull gently on the filament. Pull while the extruder slowly reverses, but do

not pull too hard or you may break the filament.

After the filament is removed from the top of the extruder, press the “M”

button until you are returned to the “Unload right” menu, shown below.

Reconnect the feed tube after this process is completed.

L. Cool Down (Optional)

Before you can leave the 3D printer, all the fans need to stop running,

signifying that the printer is cool enough to be turned off. To speed this

process up, the cool down function can be used.

To use this feature, select: Preheat > Cool!

(If this option is not available, select Preheat > Start Preheat!, then select

Preheat! > Cool!)

Figure 12 - Unload Filament

Figure 13 - Cool Down

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Sin comentarios

MakerBot Replicator 2x Manual de usuario Pagina 15