MakerBot Digitizer Manual de usuario descargar pdf (Pagina 31)

You are almost ready to begin your ﬁrst scan, but ﬁrst you have to to calibrate your new

MakerBot Digitizer. The calibration routine ensures that the position of the turntable and

lasers are recorded accurately so your MakerBot Digitizer can produce the best scan possible.

Recalibrate the turntable and lasers about once a week—or every 20 scans—to make sure

that scan quality remains constant. If you move, bump or drop your MakerBot Digitizer, the

positions of the lasers and turntable might change slightly. In any of those cases, you might

need to recalibrate the lasers and turntable. To run the calibration routine at any time, go to

the Scanner menu and choose Calibrate Turntable & Lasers.

SETTING UP YOUR MAKERBOT DIGITIZER

CALIBRATE YOUR MAKERBOT DIGITIZER

Ensure that the MakerBot Digitizer is

powered on and connected to your

computer. A message will appear

indicating that your MakerBot Digitizer

is new and needs to be set up.

Click Get Started to proceed.

MakerWare for Digitizer will explain how to make sure your MakerBot Digitizer is ready to

produce a great scan. Follow all three steps before clicking Continue.

Note: It is not possible to exit the calibration routine once it has started.

1 Open MakerWare for Digitzer

2 Check Your Location + Lighting

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 73 74

Sin comentarios

MakerBot Digitizer Manual de usuario Pagina 31